This 2550c has a very loud squeak that seems to be originating from the left rear of the copier. It has characteristics of a squeaking clutch but after removing rear cover and listening to machine make copies, I dont think its a clutch. It only squeaks when the lower motor (feed/developer ) is turning. The noise seems like its deeper inside. Normally, I would just tear into it and look for an issue but this copier is in a construction trailer with an inch of red clay dust everywhere. I'll need an extra change of clothes everything is so dirty. So, any suggestions on this that might save some agony ? Squeak, Squeak, Squeak
-
-
Re: E2550c Loud Squeak
I've encountered the loud squeak from 2nd transfer unit, problem resolved after lubricated the 2nd transfer roller. -
Re: E2550c Loud Squeak
Remove the black grease on the paper exit assembly bushings and replace with with some super lube.
Comment
-
Re: E2550c Loud Squeak
Take a glance at the black developing unit bearings. I've seen quite a few of these seize up and squeal. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment