CF60 error in EStudio Toshiba 232

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • onlineprofitinternetshop
    Technician
    • Jul 2016
    • 17

    #1

    CF60 error in EStudio Toshiba 232

    Help guys I got and error code CF60 in Estudio Toshiba 232.., I search from this forum but no post of this error code. I got an answer from other says:

    "CF60 indicates Recycle Toner Transport area lock. U need to take out the process unit, remove developer unit, remove drum, drum blade & recovery blade, disposed all waste toner, make sure the gear can turn properly. Then reassembly back everything."

    but not the good answer.., Is there any solution about this problem?





  • blackcat4866
    Master Of The Obvious

    Site Contributor
    10,000+ Posts
    • Jul 2007
    • 22997

    #2
    Re: CF60 error in EStudio Toshiba 232

    Why isn't this a good answer? It seems logical to me. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

    Comment

    • onlineprofitinternetshop
      Technician
      • Jul 2016
      • 17

      #3
      Re: CF60 error in EStudio Toshiba 232

      What does it mean that gear can turn properly.? Is it the gear from developer unit.., I clean everything from the drum unit and developer unit but no effect.., Is there a possible that sensor toner is defective?

      Comment

      • laitang
        Senior Tech

        500+ Posts
        • Nov 2012
        • 627

        #4
        Re: CF60 error in EStudio Toshiba 232

        (1) Check if any foreign matter or toner flakes are on the recycle toner transport area.
        (2) Check if the auger or the gear is damaged on the recycle toner transport area.
        (3) Check if the connector (CN305) is disconnected or the connector pin is removed on the LGC board.
        (4) Check if the harness is short circuited or open circuited.
        (5) Replace the auger lock switch.

        Comment

        • didi2005
          Trusted Tech

          250+ Posts
          • May 2011
          • 401

          #5
          Re: CF60 error in EStudio Toshiba 232

          Originally posted by onlineprofitinternetshop
          What does it mean that gear can turn properly.? Is it the gear from developer unit.., I clean everything from the drum unit and developer unit but no effect.., Is there a possible that sensor toner is defective?
          Is from cleaner unit, make sure no harden toner...
          Once u remove drum & bush, u will see the auger underneath blade & gear on the side...

          Comment

          • onlineprofitinternetshop
            Technician
            • Jul 2016
            • 17

            #6
            Re: CF60 error in EStudio Toshiba 232

            I got the answer.., the switch one is defective already., thanks for those who helps..

            Comment

            Working...