If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've had no C471 errors on the updated cores, but I've seen 2 belts fail prematurely. one at about 400k, and one at 150k. I did just discover the toner build up on the top plate just before i saw the post here about it, so I believe with the increased pressure, a little extra care with the paper guides is advised.
When I replace the fuser belt or kit, I check the gap on the separation plate. Most of the time, it is within spec, but I've have
about 3 out of 10 that is off.
Comment