Toshiba E-452 Finisher Swap

[Tim C]

I have a E-452 missing a finisher... So I swapped one with a E-450 and had to change the mounting bracket to fit,, ERROR after startup.
Is there another Finisher I have to use. The one I have on is the MJ-1023

Thanks

[tsbservice]

E-450 use MJ-1023 and MJ-1024.
E-452 use MJ-1024 and MJ-1101

[Baphomet]

My friend tsbservice is very close to correct. Both 450 and 452 can use either the MJ1023 or the MJ1024 finishers with no modifications.

The 452 can also use the MJ-1101, and there is your problem. Since you stated that you had to change the brackets, that tells me that the 452 used to have an MJ-1101 installed on it.

You need to go into 08 mode and change code 1912 to 0.
0 = MJ-1023/1024
1 = MJ-1101

You will also need to install the IPC board for the MJ-1023/1024 on the logic board.

Hope that helps.

[tsbservice]

My friend tsbservice is very close to correct.

My friend Checker is absolutely correct
According to sales config docs I posted wrong information, sorry.
SH states that Great Guru is dead on spot, please disregard my post.