sys board e600 corrupt

[MUMMIM]

Hi all!

I am ussualy update hdd or firmware for e520-600. last week ago my custom call me to update hdd for his machine, i update 1st hdd it is ok. and i put the second hdd to update add appear the messenger in the screen "hdd update fail" and then i tune off the power and tune on machine but the screen is not light and machine is don't run, i can't see anything on the screen, i can't do anything ex: C - 3, 0-8...(it dont start)
change the this sys board with another machine it is too and i change the good sys board the machine run ok .The sys board can corrupt.
every body can help me to repair it , i think by myself why so...?

[ToshibaTech]

How about the NVRAM? I, myself, would not attempt to repair a board. HyTec can do it for you though.

[Toshiba911]

Hi MUMMIM !

I need the firmware for E530, E600 and up date the HDD this model.

Could you share with me. My email: shaphn@yahoo.com

Thank.

[BoBa]

firmware for E530,

unless e520 ?

[Toshiba911]

sorry Es520-600

[atudorica]

you may recover the SYS board by using a recovery jig
ask your Toshiba dealer for one
you may also rent the jig

[aalex_bom]

update

you must remove battery in SYS board, turn on within 5 to 10s , turn off copier next set up again and up date fw.
good luck

[MUMMIM]

Thanks all for help me

At My country, Toshiba dealer don't give to rent or supply that equipments so maybe i shall try to do the guides of aalex_bom.

Thank again!

you must remove battery in SYS board, turn on within 5 to 10s , turn off copier next set up again and up date fw.
good luck

[jawir]

you must remove battery in SYS board, turn on within 5 to 10s , turn off copier next set up again and up date fw.
good luck

Hi Aalex,

Are you sure the Sys Board eS600 has battery? which one?

thank you and regards