Toshib estudio 35 hard drive
I replaced the hard drive on a e studio 35 not it comes up but stays at please wait warming up. No error codes.
Do I need to do something else?
Do I need to do something else?
-
-
if it an empty HDD you need to load the firmware
and you need a download jig for that -
You may need go to 08 mode and input code 690, select 2 and enter.
This will format HDD and you are ready to go.A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.Comment
-
I do not have the jig for this copier, cna it be done via serial cable?
Also does anyone have the firmware?Comment
-
I tried the 08-690-2 and get system mode errorComment
-
HDD jumpers?A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.Comment
-
I'ves seen arcing in the trans/sep unit cause machine lockup on warming up with that model.
Just a thought.
A.Comment
-
Thanks
Thank you guys foir the suggestions it was the jumper on the new drive.
Set it correctly and did 8-690-2 all set up and going.
No firmware needed.
Thanks again.
Nikki
Comment
Comment