Toshiba E studio 351c

[Owaisebutt]

Hello !

In full color Scanning Black Txt comes brown and other color material also fades and changes color.Which are the sensors used for color scanning and which sensors are used for balck scanning...Can anyone Point out those sensors?
( For Inofrmation: I have thoroughly cleaned the Optical section.Each and every Mirror,Reflector,Lamp and even LENS) Problem is still there.

Thanks

[Mr Spock]

The machine uses the mirrors, lens and the ccd to scan. the ccd is just behind the lens. If this is the prints you are looking at then it could be the laser slit glass, or developer or calibration. It is a computer scan then it could be ccd, or a loose connection.

[Owaisebutt]

Dear Sir,

When i scan a document in black Mode its ok. But when i scan it in full color mode...it changes the Black Txt into light brown....Now please suggest me 123 steps to do....That attached print was with another machines and not with the current one.


Thanks

[toshibadale]

If this is scan only, not a print, then clean the optics and the white plate.

[Owaisebutt]

Yes Sir ! this is scan only.Cleaned the optics properly...where this white plate is placed? If its refelector then i have cleaned and if your refereing somthing else...Please guide me where it is????


Thanks

[ToshibaTech]

Try scanning in Text mode instead of Text/Photo or vice-versa. With clean optics if that doesn't do it I think you would be looking at 05 adjustments and you would need a service handbook to figure out which adjustments to make. You could try calibrations under UserFunctions>Admin>General but I do not think that will make a difference, but it won't hurt anything either.

[Owaisebutt]

Dear Friend,

I have done calibration but it gives error. Calibration for Copy or Print....both gives error....Tried to adjust in 05...but with a mare improvment.

Thanks

[ToshibaTech]

If it won't calibrate you might have a problem like mentioned above; with the CCD or the connections on the SLG if you are lucky.

[ivovb]

Dear Friend,

I have done calibration but it gives error. Calibration for Copy or Print....both gives error....Tried to adjust in 05...but with a mare improvment.

Thanks

Problem with calibration? Check if there are jobs in any of the print queues. Delete all of the jobs and You will be able to make calibration.

BR