I am getting these codes while stapling. The stapler moves to the proper position but when the stapler should clinch it pulls these codes the machine was only at the customer location for a week I swapped it out and brought it in to the shop. I replaced the stapler and the finisher main board. With no luck has any seen this code and know the solution?
-
-
Re: E-studio 6530c CB50 EA50
This code still comes up intermittantly on this finisher.any ideas? -
Re: E-studio 6530c CB50 EA50
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Comment
-
Re: E-studio 6530c CB50 EA50
Did You do Toshiba's procedure like explained in SH?
BRI'll never ask if I didn't check user manual, service manual, parts list, BSI/TNI/TAD... web, existing threads.Comment
-
Re: E-studio 6530c CB50 EA50
I have had problems on other models with the ribon cables, which give the signal to the staple unit. You can repair them but it is best to replace them. No problems so far with these models though.It didn't say that I couldn't do it in the manual.Comment
-
Re: E-studio 6530c CB50 EA50
code 08 4548 : 0 = MJ 1031 and 1= MJ 1101
Just verify that maybe !!?Comment
Comment