Networking of an E-Studio 351c

[rukshan4u2c]

ok then after connecting ethernet cable (cat 5 patch wire) goto command prompt type <ping 192.168.0.13>

and send me the results when u type dont type the two brackets

[TheOwl]

The machine is also contactable over the network.

Could you please read the posts from the start and not half way through.

[Everly]

The Owl is right. The problem I am having is connecting to the machine to retriving the scanned documents on the HD. I will attempt formatting the drive when I am next at the office (won't be until next week) Seems like obtaining the firmware is going to be a problem though.

[ss12]

As mentioned in the previous posts connect via crossover cable.on your laptop/ pc goto network connections right click-goto properties then select tcp-ip.select manual then put both the copier & pc in similar ranges.next open your browser and enter the ip address of the copier you should be able to get to top access and action the settings I mentioned previously.this way you can eliminate the router as a problem.sorry if it sounds pedantic,as I don't know your expertise or experience with networking or these machines