e studio 45 chopped up copy

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • lightningjeremy
    Trusted Tech

    100+ Posts
    • Jul 2009
    • 139

    #1

    e studio 45 chopped up copy

    attached is a sample. any ideas? scanner board?20110505090718796.pdf
  • michaelc
    Field Tech

    Site Contributor
    500+ Posts
    • Mar 2011
    • 590

    #2
    Is it fine when you print to it ( if it linked up as a printer). Was the image a scan direct from that machine or copied and scanned via another machine? Is the image a copy from the ADF or from the glass. I noticed in the image some of the solids were not to great and it was skewed slightly.
    It didn't say that I couldn't do it in the manual.

    Comment

    • emujo
      Field Supervisor

      2,500+ Posts
      • Jun 2009
      • 3009

      #3
      Had ths issue years ago..tech replaced every board before we figured it out!.. Tech did a PM and got the transfer and charge wires swapped. Charge wire is a tad bit longer and was causing some arcing. Re-string all wires and make sure they're tight. Emujo
      If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

      Comment

      Working...