Toshiba eStudio 350

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tcypy1961
    Senior Tech

    500+ Posts
    • Feb 2009
    • 773
    #1

    Toshiba eStudio 350

    This Toshiba eStudio 350 has 132,000+ copies on it. It has a Time for Maintenance indicator on, and besides changing the developer and corona wires what else would need to be changed at this time?
    The copies are coming out lighter on one side than the other and I was shown a copy job the customer made where the copies progressively got lighter but I could not duplicate this problem. I am thinking the drum may need to be replaced eventhough it appears to be ok.
    Any suggestions and help for these problems is much appreciated, thank you.
    Tags: copies, customer, drum, estudio, estudio 35, job, maintenance, spacers, time, toshiba
    • Mr Spock
      Vulcan Inventor of Death

      1,000+ Posts
      • Aug 2006
      • 2064
      #2
      use the pm kit and then add a drum and maybe a fuser kit. Do not forget to reset the counters and run the dev setup. As to the light copies check the following: drum spacers on the dev unit, the gears on the rear of the dev unit, and the ground spring under the dev unit.
      And Star Trek was just a tv show...yeah right!

        Comment

        • Harry
          Trusted Tech

          100+ Posts
          • Feb 2009
          • 228
          #3
          Please clean scannerarea Mirrors and lens first see if it helps
          Reguards Harry

            Comment

            Previous template Next
            Working...