Copies stop at entrance of fuser evry time with buckle. Gears on fuser are turning. Pulled fuser; very hard to move gears unless pressure released. Is this normal??? Replace fuser or rebuild fuser for this problem??? Thanks!!!
-
-
Check Fuser Gear if the teeth inside is not missing maybee also bad Fuserbushings can do this Issues
Hold upper Fuser and turn Gears with hand if the roller wont turn it is the tee inside Fuser Gear
Good Luck -
I've had the pressure roller bushing completely fall apart twice this year on these models. Both low volume old machines.
Comment
Comment