toshiba c580 code

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • digicor
    Service Manager

    1,000+ Posts
    • Jul 2008
    • 1153
    #1

    toshiba c580 code

    i hava oci version of a 352 will run a few days then throw a c580 its related to the finisher,
    (disconnect the finisher and no code) is it the finisher or the board that runs the finisher? also could the finisher be toshiba and the machine be oci and the firmware dont jive>? but only after a few days?? no make sense...thanks for any input
    Tags: 352, code, finisher, firmware, lgc, nec, run, sense, toshiba, version
    • Mr Spock
      Vulcan Inventor of Death

      1,000+ Posts
      • Aug 2006
      • 2064
      #2
      Re: toshiba c580 code

      Usually either the daughter card on lgc pwb or the finisher pwb. If this has a punch unit that could be the culprit. And yes it could be bad firmware but doubtful. I would also check wall power. TECO is not the best on power.
      And Star Trek was just a tv show...yeah right!

        Comment

        • digicor
          Service Manager

          1,000+ Posts
          • Jul 2008
          • 1153
          #3
          Re: toshiba c580 code

          have you heard of this solution?
          Toshiba E Studio Error code C580 is communication problem between IPC board and finisher unit.

          The ipc pcb and the main pcb on the finisher are not matching up.

          If you are installing new finisher it has to match: the ipc pcb and the chip on the finisher,
          set 08-1912 to "0" or "1".

          its not a new finisher, but we get equipment from all over and mabey these two were not together initially....

            Comment

            • Tricky
              Field Supervisor

              Site Contributor
              2,500+ Posts
              • Apr 2009
              • 2620
              #4
              Re: toshiba c580 code

              Originally posted by digicor
              have you heard of this solution?
              Toshiba E Studio Error code C580 is communication problem between IPC board and finisher unit.

              The ipc pcb and the main pcb on the finisher are not matching up.

              If you are installing new finisher it has to match: the ipc pcb and the chip on the finisher,
              set 08-1912 to "0" or "1".

              its not a new finisher, but we get equipment from all over and mabey these two were not together initially....
              Has 08-1912 fixed it?

              In my limited knowledge of Toshiba (estudio2500) 08-1912 if set wrong will generate a c580 all the time and not work intermittently as you describe but then its a different model...

                Comment

                • digicor
                  Service Manager

                  1,000+ Posts
                  • Jul 2008
                  • 1153
                  #5
                  Re: toshiba c580 code

                  no the 1912 was set correctly, so im guessing its either the finisher board or the onboard board.LOL im going to replace the finisher.

                    Comment

                    Previous template Next
                    Working...