E-studio 160 message

[Guest]

Hi, does anyone know how to get rid of maintenance/drum message? Imaging unit was replaced.

[Mr Spock]

08-673 set but ONLY if you actually replace the parts required.

[elcondor]

before enter code 0+8 673 then 0+8 340 code 27000 to enter 0 and press set.. no more again a sign

[tech1224]

hit your program key then *#** then go to test mode, maintance, and the memory rewrite. enter E25762. us # 4 to make the E. then hit set. then enter 00. it will then go to E25763 enter 00 again. repeat until it gets to E25766. I am pulling all of this straight from memmory but I beliave it is correct I will check it out when I get to work tomorrow.

[ogye]

Thank You All

Thank you all for the replies, It worked fine. Since I did replace the process unit (imaging unit?), I just wanted the message "maintenance/drum" to disappear. Thank you all for your help.

[elcondor]

08 251 you must clear change to "0" this code