On a few machines I work on where the user duplexes a lot, we are getting called quite a bit for jamming. The fuser entrance plate is getting a ridge of toner built up on it. We have tried replacing the guide and cleaning off the painted surface, but we still have to go back and either clean it or replace it.
Toshiba E-Studio Jamming at Fuser Entrance Guide
Collapse
X
-
Re: Toshiba E-Studio Jamming at Fuser Entrance Guide
My first guess was that you used compatible toner and from that might have came your problem. Any toner built up on the fuser rollers? Which of the toshiba models are we talking here?Comment
-
Re: Toshiba E-Studio Jamming at Fuser Entrance Guide
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
-
Re: Toshiba E-Studio Jamming at Fuser Entrance Guide
It's just one model the E Studio 5500C.Comment
-
Re: Toshiba E-Studio Jamming at Fuser Entrance Guide
De tone the machine running a load of sky copies then reset up the dev with a lower value then default the exposure to photographic and set up toner save on print might work and save wonga on the toner this works well on the 455 rangeComment
Comment