CBE0-E/S 3540c w/MJ-1106 & MJ-6103N puncher

[Guest]

Machine starts by folding horribly, then throws the CBE0-folding motor (M17) abnormality. I took the rear cover off to see whats what, fire the machine up. The machine comes to life then...EA40-open cover. The I/F is stating that there is also a stationary jam in the stationary tray paper path-which there is none. Also the machine boots oddly. The finisher normally makes a serious racket just to do nothing, but this one doesn't do squat. Now i have recently installed v. 3453 F/W. Could this be to blame, partly anyway? My next thing to try is re-flashing the finisher & puncher boards.
Anyone got any ideas?
Toshiba eStudio-3540c 69,900 pgs(63k-B/W 6k-Color)
MJ-1106 Saddle Finisher
MJ-6103N Hole Puncher

[canonbundy]

Re: CBE0-E/S 3540c w/MJ-1106 & MJ-6103N puncher

Machine starts by folding horribly, then throws the CBE0-folding motor (M17) abnormality. I took the rear cover off to see whats what, fire the machine up. The machine comes to life then...EA40-open cover. The I/F is stating that there is also a stationary jam in the stationary tray paper path-which there is none. Also the machine boots oddly. The finisher normally makes a serious racket just to do nothing, but this one doesn't do squat. Now i have recently installed v. 3453 F/W. Could this be to blame, partly anyway? My next thing to try is re-flashing the finisher & puncher boards.
Anyone got any ideas?
Toshiba eStudio-3540c 69,900 pgs(63k-B/W 6k-Color)
MJ-1106 Saddle Finisher
MJ-6103N Hole Puncher

On the rear of the Exit Roller side of the Finisher is a belt driven by gears - the bushings wear - swap the 2 bushings, will get you out of trouble till replaced.

[tech07]

Re: CBE0-E/S 3540c w/MJ-1106 & MJ-6103N puncher

I'm fighting the same thing. Can you be more specific on bushing ? Prt # or pic ?