[Dead] 3540c turned off while firmware updating

[jerryl]

hey just asking is their anything that you can do if a Toshiba photocopier turns off while firmware updating and when turning it back on, it just turns on for 3 seconds and the turns off again and repeats.

m/c is a 3540c
firmware version was 3403

[ss12]

No you'll have to order the firmware jigs from toshiba.These will force update the firmware

[TheOwl]

Re: 3540c turned off while firmware updating

As above.

[canonbundy]

Re: 3540c turned off while firmware updating

hey just asking is their anything that you can do if a Toshiba photocopier turns off while firmware updating and when turning it back on, it just turns on for 3 seconds and the turns off again and repeats.

m/c is a 3540c
firmware version was 3403

I don't believe Jigs will change anything - you have a Short Circuit, check braided cable from Control Panel to Pcb for pinched wires etc - reseat all PCBs incl RAM - disconnect all addons also, then ensure the Unit boots ok (even if Display shows machine pikkie), before attempting to update FW - and ensure the FW is correct for this MODEL
.

[TheOwl]

Re: 3540c turned off while firmware updating

Chances are that the machine was turned off accidentally or the power went out in which case, the JIGS will fix everything.