xerox 7132

[cliffhangers]

Xerox 7132 displayed 010-333 how can i clair it .and i have forgotten the password.

[adriansto]

Re: xerox 7132

Xerox 7132 displayed 010-333 how can i clair it .and i have forgotten the password.

Fuser overheat in center
Be sure the fuser is driven and rotate.
Also can be a software problem.
This code must be reset from service menu.
What machine software ?

[Mukasa]

Re: xerox 7132

Fuser overheat in center
Be sure the fuser is driven and rotate.
Also can be a software problem.
This code must be reset from service menu.
What machine software ?

• To clear this fault, first remove the cause, next clear the value of NVM [744-248] to "0", and then turn the power OFF then ON.
  The flag of NVM [744-248] indicates 0: Normal, 1: NCS-Center abnormal high temperature value, 2: STS-Rear abnormal high temperature value, and 3: NCS and STS high temperature error.
  
  Check whether foreign substances or paper is wound around the Heat Roll.
  
  
  Turn the power OFF, disconnect the Main LVPS connector P/J1 and P/J2.
  
  At the PWB, measure the resistance between P/J1-3 and P/J2-3/4.
  Is the resistance infinite? Yes No Unanswered
  Replace the Main LVPS ( PL 18.1)
  
  
  Replace the following parts in sequence: Replace the Fuser Assembly ( PL 7.1).
  
  • Check the sw version of the controller sw - reload Software ( GP 7)
    
  • Fuser Assembly ( PL 7.1)
    
  • MCU PWB ( PL 18.1)
  
  
  
  
  
  
  
  
• When turning the power OFF, turn OFF the power switch first and then the main power switch.