Xerox 4595 Error code 010-315---HELP

[printprocc]

Hey everyone, hopefully someone can shed some further insight as to what to check. Xerox support site only tells me to check the fuser draw, duplexer tray and cycle power.. DOne all that simple stuff and nothing changed. Rebuilt the fuser section with a new fuser roller and heat roller..Still no change. Checked to make sure the main contact for the fuser drawer was clean and seated properly...What else should I be looking at??? This happened during an active run..Just stopped with this error and obviously wont go again..Thx

[Phil B.]

Re: Xerox 4595 Error code 010-315---HELP

check this out

Xerox 4595 Copier/Printer Support

[printprocc]

Re: Xerox 4595 Error code 010-315---HELP

Thx for the reply.. Yes this is where I started.. Did all this and no change.. I can go back over it all a third time and maybe look closer but I doubt the result will change

[Phil B.]

Re: Xerox 4595 Error code 010-315---HELP

Thx for the reply.. Yes this is where I started.. Did all this and no change.. I can go back over it all a third time and maybe look closer but I doubt the result will change

so the door magnets are straight and tight?

[printprocc]

Re: Xerox 4595 Error code 010-315---HELP

Yes they all appear to be.. Everything seats nicely and the magnets are firmly planted in what looks like the proper position.. I will try to post pics from my phone..brb

[printprocc]

Re: Xerox 4595 Error code 010-315---HELP

Hmmm having difficulty uploading pics

[printprocc]

Re: Xerox 4595 Error code 010-315---HELP

20171003_151923.jpg20171003_151951.jpg20171003_152030.jpgFinally.
Sorry for the delay, it's been busy. SO From what I see all the magnets and associated latchets appear to be straight and contact properly.