Xerox workcentre 5790 R3 temperature

[RICFOWLER]

Getting a message on a Xerox 5790 that reads please wait adjusting fuser module R3 temperature , is this something that can be reset or is this a bad fuser component can someone provide me with the settings information if possible

thank you

[adriansto]

Re: Xerox workcentre 5790 R3 temperature

Try with another fuser module.
If the error remain can be a problem with iot pwb

[Phil B.]

Re: Xerox workcentre 5790 R3 temperature

Getting a message on a Xerox 5790 that reads please wait adjusting fuser module R3 temperature , is this something that can be reset or is this a bad fuser component can someone provide me with the settings information if possible

thank you

is this after a long run?
what have you done to it?
did you clean the exhaust fan for the fuser?

so little info to ask for advise