Friends
I have two problems in WC7545 machines. Machines are 110V
First -
Job in the print queue was showing processing and could not get deleted even after rebooting the machine.
Loaded firmware V.06112122703404.
After Reloading firmware machine started displaying WC7525. Re-seat alla connector and Cleaned Both Ram and Flash/NVM module.
Also tried with sw V.06112122821500 with no luck. Removed and re-seat NVM battery with no effect.
Second -
Hard Disk error and formatted same on PC ( Fat 32) after displaying fault code 6 on controller, SBC PWBA.
Now machine display is blank and on SBC Controller Display Nos are fluctuating in sequence - 0 to 2 to 4 & back 0-2-4.
Please suggest how to proceed further, I am really blocked mentally. Since both the machines are far away I cannot try some components from one to other.
Regards & Thanks in advance
I have two problems in WC7545 machines. Machines are 110V
First -
Job in the print queue was showing processing and could not get deleted even after rebooting the machine.
Loaded firmware V.06112122703404.
After Reloading firmware machine started displaying WC7525. Re-seat alla connector and Cleaned Both Ram and Flash/NVM module.
Also tried with sw V.06112122821500 with no luck. Removed and re-seat NVM battery with no effect.
Second -
Hard Disk error and formatted same on PC ( Fat 32) after displaying fault code 6 on controller, SBC PWBA.
Now machine display is blank and on SBC Controller Display Nos are fluctuating in sequence - 0 to 2 to 4 & back 0-2-4.
Please suggest how to proceed further, I am really blocked mentally. Since both the machines are far away I cannot try some components from one to other.
Regards & Thanks in advance