Print Image distored, Xerox DC700i

[PaulNeB]

Hello,
What could be the cause of this?
Xerox DC700i Print image at SRA3 format in the pressure direction on the
left 3-4 mm longer than right. All colors suitable.
Exchange the IBT-Belt the right thing, Laser, Sensor?

[adriansto]

Sorry but what is the pressure direction? Can you post image of the print?

[PaulNeB]

Sorry but what is the pressure direction? Can you post image of the print?

Image not possible at the moment.
Paper 13" x 19"
A frame 450 x 300 mm
One frame side 450 mm, other side 454 mm.

[adriansto]

Usually the backup roll ( inside the IBT asssy ) is worn out and there is different pressure between inboard and outboard sides of paper.
After replacement must be run trapezoidal adjustment.