Xerox Versant 80 error 99-395

[azehnali]

have a xerox versant 80 with error 99-395
it will print one sheet then error
replaced the whole fuser ,BTR and Btr charge board under the BTR assembly and nothing chnaged
anyone have any other ideas
thanks

[xcopytech]

Re: Xerox Versant 80 error 99-395

Did you adjust nvm for fuser encoder

[azehnali]

Re: Xerox Versant 80 error 99-395

I have not because I dont know what it is
I have swapped fusers in the past many many times to narrow the causes in the past and never had issues with the encoder nvm not being changed

[xcopytech]

Re: Xerox Versant 80 error 99-395

Fuser belt assy or complete fuser

[azehnali]

Re: Xerox Versant 80 error 99-395

complete fuser

[xcopytech]

Re: Xerox Versant 80 error 99-395

If you replace fuser (pressure roll, fuser belt assy and frame) then you also replace fuser encoder.
Then should read value from encoder and adjust encoder nvm

[azehnali]

Re: Xerox Versant 80 error 99-395

the fuser assembly is from another machine that I dont know the nvm
I have done this many times and never had an issue with the encoder nvm before
also it does exactly the same thing with old and new fuser
if you print one sheet it comes out and after it errors

[xcopytech]

Re: Xerox Versant 80 error 99-395

There is eureka post with same problem.
Try to remove nvm pwb from mcu.
I will try yo find that post and send you

[azehnali]

Re: Xerox Versant 80 error 99-395

thanks

[cachondo]

Re: Xerox Versant 80 error 99-395

There is eureka post with same problem.
Try to remove nvm pwb from mcu.
I will try yo find that post and send you

hi i have the same proble i have changed whole and the same problem can you send me the post please

[azehnali]

Re: Xerox Versant 80 error 99-395

do you get the error after you run one print?
describe exactly what happens

[Reeves]

Re: Xerox Versant 80 error 99-395

do you get the error after you run one print?
describe exactly what happens

I have the same problem after one print the error comes

[nicaciobhz]

same problem too