[Error Code] Xerox 700 rip fiery e10-02

[marcocigna]

Hello, I need help, I have a xerox 700 printer with rip fiery integrated e10-02, everything was fine until yesterday now it doesn't want to know more than going to 00 on the service panel, it gives me an F3 code that I can't decipher . if anyone can help me thank you

[xcopytech]

Re: Xerox 700 rip fiery e10-02

There is no F3 code in service manual.
If you checked hardware (hdd, memory, fans) then try to reload system software

[marcocigna]

Re: Xerox 700 rip fiery e10-02

I tried, but I can't, because it's really stopped at f3, even when moving the levers on the front panel. I state that by connecting vga to monitor it does not give any signal

[xcopytech]

Re: Xerox 700 rip fiery e10-02

Software download from usb

[marcocigna]

Re: Xerox 700 rip fiery e10-02

Download del software da usb

i did put it on usb with fiery usb setup tool, the moment i put the pen drive on the fiery and put it in bootloader mode, it stays stuck at f3, please help me

[adriansto]

Re: Xerox 700 rip fiery e10-02

i did put it on usb with fiery usb setup tool, the moment i put the pen drive on the fiery and put it in bootloader mode, it stays stuck at f3, please help me

Dimm memory bad. Replace it.

[marcocigna]

Re: Xerox 700 rip fiery e10-02

ok, thanks, I'll try where I can buy it, the model is this UG64T7200L8DR-4ARF, I found one of these from a seller who is a few km away from me MICRON RAM DDR2 400 MHz MT18HTF12872Y-40EA2 1 GB ECC PC2-3200 CL3

[marcocigna]

Re: Xerox 700 rip fiery e10-02

Thanks for replying to my post, I fixed it by replacing the ram bank