initialised all nvm on xerox 570 now printer is showing 045-315 error

[Shahn]

initialised all nvm on xerox 570 now printer is showing 045-315 error

[adriansto]

Re: initialised all nvm on xerox 570 now printer is showing 045-315 error

initialised all nvm on xerox 570 now printer is showing 045-315 error

If you worked on machine then:

• Check that the Flat Cables are seated at the ROS Assembly (Y, M) and at the MCU PWB.
  
• If the Flat Cables are seated correctly, replace the Flat Cable.
  
  
  If this error appeared without worked on machine probably defective nvms from machine pwbs.
  Try to reset the nvms again.
  
  

[Shahn]

Re: initialised all nvm on xerox 570 now printer is showing 045-315 error

If you worked on machine then:

• Check that the Flat Cables are seated at the ROS Assembly (Y, M) and at the MCU PWB.
• If the Flat Cables are seated correctly, replace the Flat Cable.
  
  
  If this error appeared without worked on machine probably defective nvms from machine pwbs.
  Try to reset the nvms again.

i did reset it again , but no use... can anyone tell me nvm codes for that issue please !!

[WIWA]

Re: initialised all nvm on xerox 570 now printer is showing 045-315 error

initialised all nvm on xerox 570 now printer is showing 045-315 error

don,t know the reason for nvm inizialization ,assuming you did not work on laser units , so lets start did you enter manually the nvm factory values (paper located at tray 1or 2 side) if not should be your first step after that enter the newest developer housing adc sensor values ,turn it off/ turn machine on with open door and try to get in diagnostic and try a procon on to push the machine to adjust if everything goes well do adjustments like tray 5 , IBT belt tracking as so on.

Hope this helps,

Wiwa 72 Gonzos build v.1.0