Restting Charge Corotron

[NuBankTech]

I replaced this part along with the Black drum and the Charge corotron still says "replace now (call for Service)" under the 'Consumables' tab. Any ideas on how to reset this, after getting a 091-311 error i found that the black band was caused by the Corotron not moving so wherever the head is the black banding happens on the paper.

Thanks again for all of your help.

[NuBankTech]

I have also reset HSFI chain link 954-841 to 0 still no worky.

[johnner66]

check the cc cleaner move it to front n see it move after on the m/c try resit the charger if no then check on the cc cleaner motor

[copymachine]

Check sensor in front (cleaner position) Usialy it not in position, then corotron moving motor.

[NuBankTech]

I think it might me the motor, from the day I replaced the Corotron the motor has been clicking like crazy. I noticed if I spin the bar making the brush go all the way to the back the Black band disappears.

[TechMate]

I replaced this part along with the Black drum and the Charge corotron still says "replace now (call for Service)" under the 'Consumables' tab. Any ideas on how to reset this, after getting a 091-311 error i found that the black band was caused by the Corotron not moving so wherever the head is the black banding happens on the paper.

Thanks again for all of your help.

ec091-311 is a CC Cleaner motor failure. You just might need to turn the power OFF then ON again. If it's not cleared, then you need to replace the CC cleaner motor. You will also need to check the condition of the scorotron cleaner motor if OK, to avoid the "solid black band"

[pitaspotpr]

Re: Restting Charge Corotron

I change the cc cleaner motor and give me the same code fault 091-311. I think that the sensor isn't in the position. Any idea to solve this?