DC3535 tray5 margins heavyweight

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Goshe
    Trusted Tech

    100+ Posts
    • Jul 2009
    • 118
    #1

    DC3535 tray5 margins heavyweight

    I have dc3535 with Fiery and when printing on heavyweight from bypass the margins are not correct.I know that I have to perform manual NVM procedure somewhere in chain 742.

    Can anyone help me with this or give instructions for links in that chain?
    Tags: dc3535, heavyweight, margins, tray5
    • davidj7
      Service Manager

      Site Contributor
      1,000+ Posts
      • Jan 2009
      • 1107
      #2
      do you have pws ?
      a machine is only as good as your tech : source:screwtape ; the scary one

        Comment

        • Goshe
          Trusted Tech

          100+ Posts
          • Jul 2009
          • 118
          #3
          Yes I have pws and when I'm trying to adjust margins for heavyweight I get the message that I have to perform manual NVM procedure

            Comment

            • davidj7
              Service Manager

              Site Contributor
              1,000+ Posts
              • Jan 2009
              • 1107
              #4
              no , u can do it from pws.You have to write the nvm values after adjusting.that option is also available on the same page .
              a machine is only as good as your tech : source:screwtape ; the scary one

                Comment

                • Goshe
                  Trusted Tech

                  100+ Posts
                  • Jul 2009
                  • 118
                  #5
                  davidj7, I tried it can't be done.I set on the machine that the tray5 is only for heavyweight and it must be done with manual NVM procedure :|

                    Comment

                    Previous template Next
                    Working...