Dcc400 error 008-629~ 630

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ck1
    Trusted Tech

    250+ Posts
    • Apr 2008
    • 485

    #1

    Dcc400 error 008-629~ 630

    May i know to solve this problem ? i try regicon setup cycle Skew fine setup ok , but in/out setup and center setup adjustment NG . what happen ? thanks
  • ck1
    Trusted Tech

    250+ Posts
    • Apr 2008
    • 485

    #2
    any idea ??

    Comment

    • wlloh08
      Technician
      • Jun 2010
      • 15

      #3
      During regicon any error? Did the regi sensor is OK or block by any toner? Pls try to clean and redo again. If fail. Try to reset MCU NVM

      Comment

      • copytech200X
        Trusted Tech

        250+ Posts
        • Apr 2009
        • 264

        #4
        clean up MOB sensor

        Comment

        • ck1
          Trusted Tech

          250+ Posts
          • Apr 2008
          • 485

          #5
          Originally posted by copytech200X
          clean up MOB sensor
          done but still same , during regicon NG .....

          Comment

          • copytech200X
            Trusted Tech

            250+ Posts
            • Apr 2009
            • 264

            #6
            check yellow and magenta drum is it scratched and ibt belt?if NG replace then redo regi adjustment DC685(color registration)

            Comment

            • pepperbrick
              Technician
              • Mar 2009
              • 17

              #7
              try replacing with a new mob sensor.

              Comment

              Working...