Xerox 5655 does not recognize HCF A5 paper tray

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • artphil
    Trusted Tech
    • Aug 2008
    • 155

    #1

    Xerox 5655 does not recognize HCF A5 paper tray

    Hi guys,

    I have an Xerox 5655 here with an additional paper tray on the left side.
    The machine doesn't seen to recognize the HCF A4 Papertray on the left side.
    I think it has something to do with the software level of the machine.

    Can someone help me out since it's an really nasty problem...

    Kind regards,

    Artphil
  • hana_freak
    Technician
    • Oct 2008
    • 44

    #2
    Only copier or the machine has the network controler? Can you send the error codes that ones machine showed on service mode?

    Comment

    • artphil
      Trusted Tech
      • Aug 2008
      • 155

      #3
      Error codes WC 5655 with HCF

      Hi Hana_Freak

      This is the code I get.

      03-366

      Hope you can do something with these codes.

      Kind regards,

      Artphil

      Originally posted by hana_freak
      Only copier or the machine has the network controler? Can you send the error codes that ones machine showed on service mode?

      Comment

      • hana_freak
        Technician
        • Oct 2008
        • 44

        #4
        Many causes can do this error. You tried to restore NVM from MRD disk? Or do a dC132 NVM initialization/Machine Variable NVM?

        From service manual:
        Description
        03-300 The IOT PWB has detected a communications failure with the tray 5 module.

        Initial Action

        WARNINGSwitch off the electricity to the machine, GP 14. Disconnect the power cord from the customer supply while performing tasks that do not need electricity. Electricity can cause death or injury. Moving parts can cause injury.
        • Check the condition of P/J501 on the sleeved harness from the tray 5 module, paying attention to the condition of the pins.
        • Check that P/J501 is correctly and securely connected at the rear of the machine.

        Procedure
        1. Go to Flag 1 and check the wiring. Repair the wiring as necessary, GP7

        2. As necessary, perform the following:.
          • Perform OF7 IOT Diagnostics RAP.
          • Install a new tray 5 control PWB, PL 7.68 Item 8
          • Install a new IOT PWB, PL 1.10 Item 2

        Comment

        Working...