Xerox C226

[boris1100]

Re: Xerox C226

Hi, this would be very kind of you and very helpful for me!
Thanks a lot in advance

Best regards
Boris

[boris1100]

Re: Xerox C226

I did it! - a lot of thanks to you technicans for your helpful information.
All DV-gears are broken!
I replaced those gears by removing the transfer belt assembly, the toners and drums

Dropped a pic of those 4 evildoers...lol gear_007N01597.jpg

Have a nice time

Best regards

Boris

[bmt_hr]

Re: Xerox C226

Great !!!!

[boris1100]

Re: Xerox C226

Yessssss! - and a special Thank You to you for your instructions!
The first attempt was by me, but my arms didn't fit into it.
So I asked my wife to help me out - and she reached without any problems
those crazy gear and lifted it without any tool - only with her fingers...
The whole action took about 15 minutes...

Have a nice Sunday
Best regards
boris

[gilead]

Re: Xerox C226

I have a similar problem. Toner, drums, and fuser changed, still repeating cyan and magenta lines every 58mm adjacent to direction of paper.
Can see tiny cracks in gears which drive two of the drums and both magenta and cyan lines left at 58mm intervals on the transfer belt. These gears do not look like the ones on the pic . They have a drive slot corresponding to the recess on the drum drives.

All help appreciated.

Thanks

[mgwhausen]

Re: Xerox C226

Have the same problem.

Can I take used gears from a Sharp AR-C 160?
Seams to be the same as a C226