Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

[mdm]

Hi, hoping that someone seen this problem before.

Working on a Xerox WC 5775 There are three sets of faults: 10320, 10380. I tried

another working fuser and the same problem. Any help appreciated.

Thanks.

mdm

[xeroxsharp]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

Bad LVPS or NVM corrupsion.

[adriansto]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

Bad LVPS or NVM corrupsion.

Before check LVPS or do NVM init you must take a look at the fuser connector located in machine especially at thermistors contacts.

[mdm]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

Thanks Xeroxsharp and Adriansto,

I am ordering a LVPS and IOT PWB to take care of problem, I will keep you all inform.

Adriansto, could give me a little more info on what to look out for on the fuser contacts.

Thanks.

[adriansto]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

10-380 error code mean reading differece between the two thermistors from fuser assy.
May be a bent contact(s) in fuser conector located in machine. You exclude the contacts connector on fuser assy because already tried two fusers assy and get same error.

[mdm]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

10-380 error code mean reading differece between the two thermistors from fuser assy.
May be a bent contact(s) in fuser conector located in machine. You exclude the contacts connector on fuser assy because already tried two fusers assy and get same error.

Thanks Adriansto, I will check fuser connector.

[kinga sithup]

Re: Xerox wc5775 Ready To Copy, Please wait adjusting fuser module (R3) Temperature

Were you able to solve this problem? Could you please help me I have same problem.