Re: DC6060 error 9-343
Check the spring that moves the belt edge sensor, I had the same error but with DC2060 after cleaning the interior of the machine I had accidentally unlinked it. There is a thread in this forum http://www.copytechnet.com/forums/xe...009-343-a.html . Not sure the NVM for resetting the error is the same in 6060. You can do it without PWS but honestly I think servicing DC6060 without PWS is not a good idea.
DC6060 error 9-343
Collapse
X
-
Re: DC6060 error 9-343
tomorrow after noon I'll be near the machine and I'll try again to fix it
I'll till you
Thank you all for helping me
and may we'll contenu tomorrowLeave a comment:
-
Re: DC6060 error 9-343
maybe I know Whats that PWS
Just Explane to me please
I know how to exchange NVM Values and to Replace every Part and I can fix every thing
I know where the proplem is and I cleaned the IBT and the sensor but the IBT moves again and again
I have't the software for the machine from Xerox
I'm not a techLeave a comment:
-
Re: DC6060 error 9-343
DC 6060 is different kind of machine. It has almost diagnosis on external software named pws tool. PWS ( Portable Workstation Service) is a laptop with software on it named gsn or pws This is the main software xerox tech use for repair xerox boxes. On main pws run pws tool which is machine specific software.
DC956 is a specific routine from pws tool. If you want to self service DocuColor 6060 you need service manual, pws and pws tool. If you want more details send me a mail.Leave a comment:
-
Re: DC6060 error 9-343
wow if you dont know what pws is ,you better call a tech.
To run Belt edge routine you have to use pws.Leave a comment:
-
Re: DC6060 error 9-343
thank you for helping me adriansto
I'm Expert With DC12
I don't know pws ???
what is this PWS ??
I got this PDF file from a frind and I understand every thing but this thing "DC 956 Belt Edge Learn routine" I did'tLeave a comment:
-
Re: DC6060 error 9-343
I think that you can fix that without PWS .
Just steer the belt back in place, check to see that the patch is good and shiny. Check that the edge sensor is touching the belt ( belt tends to curl on the edges and not touching the sensor).
Then power off and power on.
This will trigger the belt edge learning procedure.Leave a comment:
-
Re: DC6060 error 9-343
You need pws with pws tool for this machine.
What version of software ( firmware ) the machine have ?Leave a comment:
-
DC6060 error 9-343
How can I arrive the option
DC 956 Belt Edge Learn routine
to fix the IBT place
regards MontherTags: None
Leave a comment: