If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
service manual need how to go into wcpro 35 service mode
Re: service manual need how to go into wcpro 35 service mode
Originally posted by pc123321
yes to see
to clear the message replace waste toner box
i try two new clean unused well pack box ,inside waste toner box , give me the same message ,
yesterday i try once disassembly the power unit and put it back ,test ,give me the same message ,
tomorrow i try again
the whole unit gear transfer i took out before ,there are two small screw fasten to the sensor frame (left side white plastic sensor cover)
sensor frame position will change ,it depend on two alignment screw holes
Re: service manual need how to go into wcpro 35 service mode
Originally posted by bojans
Check PM!
the waste toner box door switch , i used wire to short circuit then the screen message only replace toner box
the fault error code 09-380 disappear , but the screen message is replace waste toner box 03-700,03-785 only power
to continue check out ----tomorrow reseated the waster toner box switch
Comment