4110 Restarting

[davidj7]

HI
My 4110 which was working perfectly fine till closing yesterday . It keeps on restarting when the power is turned on .

I opened the front door and powered it . Then everything comes fine but after i close the door it restarts again.

I cleaned the RAM's . besides that i donno what to do or look . Any ideas.

Thanks

[adriansto]

Re: 4110 Restarting

Serach in 4110f_sources_V318 CD or in eureka tips
You'll find a lot of checkings.

[davidj7]

Re: 4110 Restarting

i serached in eureka but I couldnt find anything close

on an update :

I disconnected the Internal RIP cable and turned on the machine . It does not restart but gives me a different window . SO now i am thinking what I have is a corrupt software on the RIP.

I have system software 3.0. Is the Rip software included with system software or should i start looking for something else.

[adriansto]

Re: 4110 Restarting

If your machine is copier printer then you have fuhjin-XC-ps-dld-1.202.6.bin file into version 3 software package. This is the controller software file for internal rip.
If you have external RIP or dfe kit installed then you need the separate software for the DFE.

[davidj7]

Re: 4110 Restarting

yes i have that file . :-) thanks a ton

[davidj7]

Its not RIP related. can you can think of anything else ?


Edit : If i pull the feeder out of the machine(fixing duplex all) , cheat the switches then it wont restart . So i am thinking there is some short circuit in feeder unit ?

Sent from my Nexus 5 using Tapatalk

[adriansto]

Re: 4110 Restarting

I will started monitoring the voltages on the LVPS.
Also cleanning the power connectors.

[Exok]

Re: 4110 Restarting

I suspect the power supply.

[seansbar]

Re: 4110 Restarting

I have had several door interlock switches fail on me. Its worth a look at.

[davidj7]

Re: 4110 Restarting

Can I have the part # for the interlock switches. I couldn't locate it on the PL


edit :bad me just the desperation . I located the Part # ordering it


Thanks