Re: WC5745 speed
nvm values can be change if you have a pws laptop, try to change the 03-003 change to 5, 03-005 change to 4 and 03-018 to 4 after that turn off and put again the usb with altboot
WC5745 speed
Collapse
X
-
Guest repliedRe: WC5745 speed
i want the PWS NVM Save & Restore tool and how to load a new nvm to my copierLeave a comment:
-
Re: WC5745 speed
Hi Please I have the same issue on 5765, please kindly send password please thank you.Leave a comment:
-
Re: WC5745 speed
Replace the software module. Part # 960K65035. Ensure the new module battery is above 2.8v
Do not install a used module as the meter reading will convert to the amount on the used module.
A new module will zero out your meter reading and this can not be changed.
Ensure that dc131 03-005 & 03-018 are both set to 4.
Set the machine speed: Enter dc131 03-012 (pw-check PM) for 5745 set this to "45"
Your NVMs will be at factory default. If you have saved your NVMs in the past you can do an NVM restore. If not, at lease make sure you run all the registration adjustments dc604.Leave a comment:
-
Re: WC5745 speed
Replace the software module. Part # 960K65035. Ensure the new module battery is above 2.8v
Do not install a used module as the meter reading will convert to the amount on the used module.
A new module will zero out your meter reading and this can not be changed.
Ensure that dc131 03-005 & 03-018 are both set to 4.
Set the machine speed: Enter dc131 03-012 (pw-check PM) for 5745 set this to "45"
Your NVMs will be at factory default. If you have saved your NVMs in the past you can do an NVM restore. If not, at lease make sure you run all the registration adjustments dc604.Leave a comment:
-
Re: WC5745 speed
Change only the yellow battery from nvm module.
Note the code from battery and ask for at the local electronic shop. Also you can find it on ebay.Leave a comment:
-
Re: WC5745 speed
Replace the software module. Part # 960K65035. Ensure the new module battery is above 2.8v
Do not install a used module as the meter reading will convert to the amount on the used module.
A new module will zero out your meter reading and this can not be changed.
Ensure that dc131 03-005 & 03-018 are both set to 4.
Set the machine speed: Enter dc131 03-012 (pw-check PM) for 5745 set this to "45"
Your NVMs will be at factory default. If you have saved your NVMs in the past you can do an NVM restore. If not, at lease make sure you run all the registration adjustments dc604.Last edited by Exok; 05-07-2015, 11:56 AM.Leave a comment:
-
-
Re: WC5745 speed
An AltBoot wouldn't have done that. It sounds more like your software module battery has dropped to less than 2.8v. Check that first before you proceed.Leave a comment:
-
Re: WC5745 speed
Change the octagon 24 c08w chip can't change the speed?Leave a comment:
-
WC5745 speed
Hi to all,
After a force alboot on a xerox wc5745, the machine speed has turn to 33.
In NVM Dc131, I try to change the speed to 45.
At 03-012 = 33 I Change to 45 with write option but the machine is asking for a password.
Does someone know this password?
Thanks & Rgds
JPTags: None
Leave a comment: