Xerox Nuvera 120 Not Seeing Multi Function Finisher

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • xtrain
    replied
    Re: Xerox Nuvera 120 Not Seeing Multi Function Finisher

    The low voltage power supply in the MMF finisher is known as a inherently defective part. and causes this problem.

    Leave a comment:


  • adriansto
    replied
    Re: Xerox Nuvera 120 Not Seeing Multi Function Finisher

    The serial cable perform the connection. Check again.
    As I said for this machine you need service manual ewspecially it is the production machine type not only copier / printer machine.

    Leave a comment:


  • tpant
    replied
    The only cables going to finisher is a 4 or 5 pin power looking cable and a db9 cable. Should there be a ethernet cable going to finisher.

    Leave a comment:


  • adriansto
    replied
    Re: Xerox Nuvera 120 Not Seeing Multi Function Finisher

    The MMF communicate using CAN bus. Check the cables connections and software version.
    The printer cant see the mff at start up.

    Leave a comment:


  • tpant
    replied
    The "mimic" in top right corner only shows feeder and print engine.

    Leave a comment:


  • adriansto
    replied
    Re: Xerox Nuvera 120 Not Seeing Multi Function Finisher

    There is a mimic on the DocuSP screen upper right hand corner or a error code is displayed ?

    Leave a comment:


  • Xerox Nuvera 120 Not Seeing Multi Function Finisher

    Just setting up a new to me Nuvera 120. It it not seeing the finisher. Any suggestions are welcome.

    Thanks
    Tom
Working...