[Error Code] RE: Xerox wide format 6605

[Mukasa]

Hi Guys,
The Xerox wideformat 6605 displays errror code 046-311 and error massage Internal power failure.
I have measured the 24volt in every place following the service manual , leading me to the IOT pwb.
I think the IOT is Locked up needs reset, but i don't know how to do it.

Mukasa

[adriansto]

Re: Xerox wide format 6605

Check IIT ( scanner) optical sensors for dirt or debris.

[Corder]

Re: Xerox wide format 6605

Hi Guys,
The Xerox wideformat 6605 displays errror code 046-311 and error massage Internal power failure.
I have measured the 24volt in every place following the service manual , leading me to the IOT pwb.
I think the IOT is Locked up needs reset, but i don't know how to do it.

Mukasa

Have you checked +24V LVPS monitor signal (24C)?

[Mukasa]

Re: Xerox wide format 6605

Have you checked +24V LVPS monitor signal (24C)?

Hello Corder,
Yes i have checked the +24 LVPS monitor signal its available. The machine fuser Warms up but doesn't get ready to copy.It can scan fine.
'
Hi Adriansto have also cleaned the IIT scanner sensors still displaying Error message' Internal System error'

[Corder]

Re: Xerox wide format 6605

Hello Corder,
Yes i have checked the +24 LVPS monitor signal its available. The machine fuser Warms up but doesn't get ready to copy.It can scan fine.
'
Hi Adriansto have also cleaned the IIT scanner sensors still displaying Error message' Internal System error'

I recommend you to dismantle the front baffle (PL 3.1 item 4 as for 6204) and try to reconnect each IIT sensor.

[Mukasa]

Re: Xerox wide format 6605

I recommend you to dismantle the front baffle (PL 3.1 item 4 as for 6204) and try to reconnect each IIT sensor.

Sorry ,i will dismanlte the IIT tomorrow and let you know the progress.

Mukasa

[Mukasa]

Re: Xerox wide format 6605

Sorry ,i will dismanlte the IIT tomorrow and let you know the progress.

Mukasa

Sorry again i have a 6605 not 6204.
6605 have no baffle it has a Scanner Assembly PL 14.1

Mukasa

[Corder]

Re: Xerox wide format 6605

Sorry again i have a 6605 not 6204.
6605 have no baffle it has a Scanner Assembly PL 14.1

Mukasa

Whatever. Get to IIT sensors and reconnect each.

[rkdigitals]

[Mukasa]

Re: Xerox wide format 6605

Hi RK Digitals and fellow Engneers,
Thanks for your support, Yes the drum interlock switch unit assy was behaving funy repaired it still the fault was still there.
I found a loose conection on one of the two fuser PWB .
Now the machie is ok
Thanks God Bless you.

[a-kprinting]

Re: Xerox wide format 6605

i had this same error it ended up being the main interlock switch for the door to image unit

[Phil B.]

Re: Xerox wide format 6605

i had this same error it ended up being the main interlock switch for the door to image unit

this thread is 7 years dead and buried.

[Matoku]

Re: Xerox wide format 6605

My Docuwide 3035 today error 046-311.
Solution. I just reconnect all the connector
On AC drive and LVPS. After reseat all and
Switch on the machine working fine. Thanks