on back of thermal head have a gear with a screw holding these gear is broken i need part number and somebody tell me if have this part
riso broken gear rz 390 ui need parts manual
Collapse
X
-
Tags: back, broken, head, manual, number, part, part number, parts, parts manual, riso, thermal head
-
Re: riso broken gear rz 390 ui need parts manual
The error code is P-19-207. I just ran across it today. =^..^=
Riso 220UI 390UI P-19-207.JPGLast edited by blackcat4866; 08-12-2014, 11:37 PM.If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: riso broken gear rz 390 ui need parts manual
On the 390/590s, if you power-cycle the riso and hear a semi-loud BANG that isn't part of it's normal bang-clang noises, but it works just fine, and doesn't make the noise again until it's turned off and back on again, check this gear. It's most likely cracked and about to destroy itself in the near future.Comment
-
Comment
-
Re: riso broken gear rz 390 ui need parts manual
No idea, but it's very common. We had 6 used Riso's in the office of which three were already broke, two already taken, and one left for me to scavenge. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: riso broken gear rz 390 ui need parts manual
only one screw one one side ,this gear turn back and forth to overcome the spring load at end via cam,
i have this case one year ago , find part ,,,
i found the part from used copy machine fuser konic c 352 with same dia and same teeth.but needed to drill two hole on gear i modify , used two screw one on each side with spring washer, you need a washer to adjust gear positionComment
-
storm180
Re: riso broken gear rz 390 ui need parts manual
Anyone have instructions on the easiest way to replace that gear?Comment
Comment