Brother MFC L8650cdw

[ChrisG]

Re: Brother MFC L8650cdw

did a search in the PM of the back flapper mentioned in the SM... no such bird...

sat on hold with TS for 20mins until I got disconnected ( must have been their break time? )

will try again later.

No worries. It's just more for curiosity now than anything else. I did misspeak with the picture numbers. #7 is the plate in front of #8 but it shows 2 screws securing it. Which is what I was trying to say, but it's Friday and my attention level to detail was low. haha

Appreciate the effort anyhow
Chris
TJL Copy

[tsbservice]

Re: Brother MFC L8650cdw

These rollers are parts of Fuser unit unfortunately. They will come separated like in picture when new Fuser is purchased.
Don't think only rolers with that little plastic guide can be purchased separate.
Fuser.jpg

[Phil B.]

Re: Brother MFC L8650cdw

These rollers are parts of Fuser unit unfortunately. They will come separated like in picture when new Fuser is purchased.
Don't think only rolers with that little plastic guide can be purchased separate.
[ATTACH=CONFIG]40418[/ATTACH]

we have determined that guide is NOT the one in question.. but thanks for trying.

[tsbservice]

Re: Brother MFC L8650cdw

Well, my bad. Interestingly they seems to omited this Back flapper holder. Only found shadow of it in MFC-L8900CDW/L9570CDW parts list.
Нevertheless, NО part number.

Flapper.jpg

[Phil B.]

Re: Brother MFC L8650cdw

Well, my bad. Interestingly they seems to omited this Back flapper holder. Only found shadow of it in MFC-L8900CDW/L9570CDW parts list.
Нevertheless, NО part number.

[ATTACH=CONFIG]40419[/ATTACH]

yup I ran into the same issue... thanks for trying

[tsbservice]

Re: Brother MFC L8650cdw

yup I ran into the same issue... thanks for trying

Lol, seems you covered the most of researching that mysterious part.
Next time maybe