If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just ran into that problem, new formatter, did the cold reset, new firmware. oem toners, IT WAS THE TRANSFER BELT! My post is in here, in the history for HP's. Good Luck.
Hello.
I want to discuss the old and dusty topic - "HP color alignment."
The purpose of the post (its further discussion) is to close this topic, at least partially.
Here goes.
1. Terminology.
The defect is googled by the words: misregistered (in SM); align, misaligned, offset, ghost (on specialized forums and "on your Internet").
Leave a comment: