HP 9050N problems

[Deano]

Hello guys, ive been down to a site today and replaced a paper pickup assembly on the 9050N, but it is still jamming in various places. Also its not alligned properly, as its missing the top of the page, like its trying to print before the paper actually gets there, and theres about just under 1inch of space on the bottom of the page!! Im rather stuck, so would appreciate the help, if anyone can

Thnaks in advance

[jeroen2005]

Hello guys, ive been down to a site today and replaced a paper pickup assembly on the 9050N, but it is still jamming in various places. Also its not alligned properly, as its missing the top of the page, like its trying to print before the paper actually gets there, and theres about just under 1inch of space on the bottom of the page!! Im rather stuck, so would appreciate the help, if anyone can

Thnaks in advance

What were the jam codes before you replaced PIU?
Is the standard paper size letter or A4/
Please give more info.

[Deano]

the error codes are the same, 13.05 and 13.09, paper is A4

[LaserSharp]

When you print a config sheet does the printer show the tray as being configured for a4? and not maybe..Letter?

[JustManuals]

This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


Paul@justmanuals.com

[Deano]

When you print a config sheet does the printer show the tray as being configured for a4? and not maybe..Letter?

yes, its configured for A4 m8. Someone told me it might have something to do with the clutch, as he reckons its trying to print to the paper before paper even gets there?
thx for ur reply m8

[Deano]

This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


Paul@justmanuals.com

ive got the manual thx, anyways it shold be free

[LaserSharp]

Maybe I was a bit confused by what you meant by the top of the page... If you mean the leading edge of the paper, which in most circumstances would be the left edge of a portrait layout...but now that I think about it, really could be either...working on assumptions here.

If the page is shifted to the right or the left of a letter as you would normally read it, then I would be looking at the registration clutch on most printers, although I have be honest when I say I've never seen that be a problem on 9050.

[Deano]

Thx for the reply m8, the black borderline on the sides are fine, its the top and bottom which is all screwed up, its atleast 1 inch out on the top and bottom, some1 else did mention the clutch, ill have to investigate further. Thx again m8

[prntrfxr]

Could be the following: Defective Paper tray > PIU torque limiters > Defective registration asm

[Deano]

Could be the following: Defective Paper tray > PIU torque limiters > Defective registration asm

its defo not the paper tray, as tried a few diff ones, so it must be Registration asm, as ive replaced the paper pickup asembly twice allready!