C7101 on Kyocera Taka Alfa 8002i. The MFP developer unit is spilling any solution to this problem will be highly appreciated. I have tried serving the dev unit several times without success.
-
-
Re: KYOCERA TASKALFA 8002i
Can you get the error to clear temporarily? If yes, enter service mode > U030 and run the developer motor. If it does not run, you might have a bad developing motor. Very similar motors are used in the KM-6550ci, KM-7550ci, KM-6551ci, KM-7551ci, KM-8002i, KM-8003i. I suspect that 302K994890 through 302K994894 are all updates in the same motor. If you manually rotate the motor you might hear loud clicking. This one was in a KM-6551ci:
DEVM-K_2.jpg
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: KYOCERA TASKALFA 8002i
700k but the MK had been changed at 500kComment
Comment