Lexmarl C748DE No Red at all

[Dave]

Re: Lexmarl C748DE No Red at all

Well, I swapped the black and magenta transfer rollers, cleaning things up along the way. Still no magenta.
Pondering...

Correct me if I'm wrong, but, I think typically with these block type laser/scanners, there are two physical lasers that do two colors each. Say, BLACK & CYAN and MAGENTA & YELLOW. If you've got yellow, you'll have magenta too.

[Lance15]

Re: Lexmarl C748DE No Red at all

I've really nothing more to add. I've never taken apart an ITB. No reason to. Sounds like this is just an exercise to "figure it out" not having to ultimately fix it for a customer?

[Lance15]

Re: Lexmarl C748DE No Red at all

Final check is to remove the laser/scanner, take it apart. See if maybe something is wrong there.

[Dave]

Re: Lexmarl C748DE No Red at all

Thank you all. The machine is fini.

Final check is to remove the laser/scanner, take it apart. See if maybe something is wrong there.

[Phil B.]

Re: Lexmarl C748DE No Red at all

Thank you all. The machine is fini.

what was the final fix?

[Dave]

Re: Lexmarl C748DE No Red at all

Jack it up and slide a new one under it.

Seriously, I believe it is the laser in the magenta position causing the problem. Could it be something in the laser unit besides the laser?yes. am I gonna take it out? no. If I had another one that I knew worked would I install it? maybe, but there's still no way for me to tell if it's the laser or the control board because I don't have a wiring diagram or schematic. I gave it a shot at saving a machine that we still have supplies for... it will now go to surplus and probably be sold on ebay as is.

what was the final fix?

[joeh]

Re: Lexmarl C748DE No Red at all

The contacts on the print cart block short to the frame. Loosen the screws on the plastic frame and put black tape behind it, to insulate it from the metal frame

[Dave]

Re: Lexmarl C748DE No Red at all

Thanks for the reply. Unfortunately the machine has been surplused. It may be on ebay by now...

The contacts on the print cart block short to the frame. Loosen the screws on the plastic frame and put black tape behind it, to insulate it from the metal frame