Lexmark C710 Color Laser Engine Error?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Photovor

    Lexmark C710 Color Laser Engine Error?

    I'm getting an "Engine Error 922" on a Lexmark C710. Don't have any reference materials for this specific model. I can find "Fuser Error 922", but nothing about "Engine Error 922". I'm not sure if the two messages are the same or not.

    Anyone have any resources they can check?
  • rschmitt
    Technician
    • Feb 2005
    • 34

    #2
    I believe it the print engine board that needs replacing.

    Comment

    • Photovor

      #3
      Before you posted the last message, I had sent an email to Lexmark support. I just told them that I had Engine Error 922. They came back with a response about the fuser. I re-sent an email to support to make sure that the two errors were about the same. I have not yet gotten word back yet.

      Comment

      • DavidEtling
        Technician
        • Feb 2005
        • 31

        #4
        C710

        I can send you the service manual on this printer, just send me your email address to davidetling@hotmail.com and I'll post it up on yousendit.com for you to retrieve!

        Comment

        • Wild Bill
          Senior Tech

          500+ Posts
          • Jul 2005
          • 774

          #5
          Originally posted by Photovor
          I'm getting an "Engine Error 922" on a Lexmark C710. Don't have any reference materials for this specific model. I can find "Fuser Error 922", but nothing about "Engine Error 922". I'm not sure if the two messages are the same or not.

          Anyone have any resources they can check?
          You are right all I see in the manual is the fuser error. On T series 922 is the print head but on these the print head is 930, 931, 934,
          935 Printhead Error. So, It has to be the fuser.

          922 Error - Fuser below maintenance count.
          Note: If selected, turn Power Saver off.
          Error codes 920, 921 and 922 may display for a cold fuser failure. A
          920 fuser error caused by low line voltage may be cleared by turning
          the printer on and off.
          Izzy

          Comment

          Working...