work center PRO 315

[vaclav borc]

can you anyone send me service manual workcener 315

vaclavborc@seznam.cz

any other code appears /U9/

many thanks

[jeanpaul]

U9 rap is that there is a problem with the HVPS or arcing on T/DT corotron assy or drum contact

[imaginGuru]

In the Xerox WorkCentre Pro 315 / 320 Usually this code (U9) comes out from:

-broken or contaminated transfer corona
-dirty charge corona
-imaging unit about to reach end of life (nylon separators of the DV unit worn/broken=drum esporadic crashing/contacting with the DV magnetic roller earthing the DV unit BIAS), (you can check the % of remaining life pressing+holding these buttons together C+2).

Anyway if you need it the service manual+parts you can get it following this link at no charge:
xpress+fast

Regards.

imaginguru

[imaginGuru]

Also check the HV metalic contacts are not bent (inside the machine).


IG.,