[Jamming] jam in fusing unite section -ineo 454-

[jakani]

hello everybody ,

i get the jam en permanent way , when i remove the paper it all folded , i thought it was the fusing unit so i changed it but still the same problem

anybody have an idea what might cause this problem ?

thanks in advance for any suggestions

[jakani]

Re: jam in fusing unite section -ineo 454-

hello everybody ,

i get the jam en permanent way , when i remove the paper it all folded , i thought it was the fusing unit so i changed it but still the same problem

anybody have an idea what might cause this problem ?

thanks in advance for any suggestions

i get somthing like this

paper_accordion.jpg

[Synthohol]

Re: jam in fusing unite section -ineo 454-

what is the actual jam code?

[EarthKmTech]

Re: jam in fusing unite section -ineo 454-

check that all the rollers are actually turning and that no belts are misplaced.

I've had the exit section 1 way clutch fall to pieces before but its pretty obvious when those rollers arent turning.

[jakani]

Re: jam in fusing unite section -ineo 454-

what is the actual jam code?

thank you for replying

there is no jam code it just show "misfeed detected remove paper as indicated ..."

check that all the rollers are actually turning and that no belts are misplaced.

I've had the exit section 1 way clutch fall to pieces before but its pretty obvious when those rollers arent turning.

thank you for replying


i noticed that when i push the "paper exit roller" to the back the paper almost passes the fusing unit , but the end of the paper still stuck in it

i will check the cluch as you said

[avecosat]

Re: jam in fusing unite section -ineo 454-

Jam code is in a tech mode , counter , jam counter .

[jakani]

Re: jam in fusing unite section -ineo 454-

Jam code is in a tech mode , counter , jam counter .

thank you

[jakani]

Re: jam in fusing unite section -ineo 454-

what is the actual jam code?

Jam code is : 30-03
thank you

[jakani]

Re: jam in fusing unite section -ineo 454-

hello

Update :

the problem of this jam caused by CL8 clutch ,

i didn't have the same clutch to replace it so i managed to use a CL7 from a bizhub c 253 adding some tweaks to make it work in place of CL8