PDA

View Full Version : Konica c284 with finisher jam J72-22


Custom Search


barber782
07-06-2017, 01:56 PM
Hi,

Got a constant jamming issue on a fs-534 finisher ( tray 2 output).
The paper enters the eject /sorter unit and jams on 2nd page in sorter.
J72-22 is code recorded. Jams from all trays.
Tested all sensors and nothing obvious yet.

Any ideas?

Sent from my GT-I9195 using Tapatalk

richmods
07-06-2017, 08:49 PM
Hi,

Got a constant jamming issue on a fs-534 finisher ( tray 2 output).
The paper enters the eject /sorter unit and jams on 2nd page in sorter.
J72-22 is code recorded. Jams from all trays.
Tested all sensors and nothing obvious yet.

Any ideas?

Sent from my GT-I9195 using Tapatalk


I found this a few days ago searching for an answer to a different problem but may be relevant to your case. I assume this is an FS-534 finisher?

http://www.copytechnet.com/forums/konica-minolta/104455-fs-534-alignment-plate-wearing.html

barber782
07-06-2017, 09:08 PM
Thanks seen that post before. But don't think it's related to the problem. First page sits into the sorter unit, and then 2nd page stops as it enters the ejector unit

Sent from my GT-I9195 using Tapatalk

s817
07-10-2017, 07:37 AM
check the bridge unit guide part no. a3ep822100 guide/7 item 17
as I have had a lot of these wear, generally at the rear and
as the paper passes it can get delayed slightly thus bringing up a
paper jam message, you will need to look carefully ( the part of guide that wears
is the raised portion )as the wear doesn't have to be severe to cause trouble

hope that helps

apollo
02-06-2018, 05:36 PM
Thanks seen that post before. But don't think it's related to the problem. First page sits into the sorter unit, and then 2nd page stops as it enters the ejector unit

Sent from my GT-I9195 using Tapatalk


Hi

what was the fix for your issue i am having same symptoms on fs534 on km454e
jam code j72-22

thanks

barber782
02-06-2018, 05:58 PM
I think it was a mixture of things. Paper in the lct wasn't flat, causing a skew. Also replaced the paddle assembly above the staple tray.

Sent from my GT-I9195 using Tapatalk

apollo
02-06-2018, 06:38 PM
I think it was a mixture of things. Paper in the lct wasn't flat, causing a skew. Also replaced the paddle assembly above the staple tray.

Sent from my GT-I9195 using Tapatalk


Thanks

Will check tomorrow visit

Custom Search