PDA

View Full Version : KM 1060 with IC-415


Custom Search


Drcopy
06-04-2018, 08:33 AM
I have a fiery that all of a sudden stopped working, there is power it and the Lans are flashing but get a "controller unconnected" message on the control panel.
I have rebooted and restarted and suggestions guys?

Drcopy
06-04-2018, 08:45 AM
Oh by the way, no leds coming up.

tech51
06-04-2018, 08:17 PM
I would try reloading the Fiery controller first.

Synthohol
06-04-2018, 11:46 PM
is the green power button lit?

Drcopy
06-05-2018, 05:52 AM
is the green power button lit?

No.

Synthohol
06-05-2018, 06:43 AM
what happens when you push it in for 3 seconds?

Drcopy
06-06-2018, 01:02 AM
Nothing really just the lan leds turn off then flash again.


Sent from my iPhone using Tapatalk

Synthohol
06-06-2018, 03:03 AM
check the HSF and mount.

byronf
06-06-2018, 08:04 PM
What version of system software have you loaded?
I had the same issue with Version 1.2 then I reloaded version 2.0 then ran the 19 patches and it connected after 10 minutes after machine booted.

Synthohol
06-06-2018, 08:38 PM
his green power button does not stay lit if i understand this. that means either a fan isnt turning or a bad PSU or the cpu is overheating.
it sounds like the fiery is just protecting itself or the power supply is tanked.

Drcopy
06-07-2018, 08:49 AM
I think it might be a power issue, if there is no led's on, except the LAN activity led.
would you replace the cpu or the power supply?

Custom Search