C6000 corrugated paper

[Konica C6000]

Hello!


I have a Konica C6000 machine and when printing 80gr paper, the paper becomes wavy. What might be the problem?


wave_2.jpgwave_1.jpg




Thanks in advance for your help.

[tulintron]

Re: C6000 corrugated paper

Good Morning. Check the fuser unit and the paper exit unit

[Konica C6000]

Re: C6000 corrugated paper

Good Morning. Check the fuser unit and the paper exit unit

Hello!


I checked the circled units. The print setting is face up.
It very rarely prints without waves, but usually there are 2-3 waves in the sheet.



check.jpg

[tech51]

Re: C6000 corrugated paper

The entry guide to the fuser with the brown looking coating on wears and can cause this.

[Konica C6000]

Re: C6000 corrugated paper

The entry guide to the fuser with the brown looking coating on wears and can cause this.

Do you think about the lower fusing roller?

I have a piece of them, i will replace tomorrow.
Thanks!

[joaopauloooo]

Re: C6000 corrugated paper

Check if the Adhesive tape of the Teflon tape is worn.
The part you should be looking for this is the "Fusing separation assembly" Part number: A1DUR74H00
Papel Saindo Ondulado - Konica PRESS C6000 - YouTube

Another thing that could cause this is humidity, try to see if it happens with low humidity paper.

[Synthohol]

Re: C6000 corrugated paper

check these gears too, there are one way gears and can crack or slip.

[Toxic]

Re: C6000 corrugated paper

If you have finisher connected to machine try to open door during printing and check at what section of process paper get wavy, could be finisher problem.

[Konica C6000]

Re: C6000 corrugated paper

Thank you all for your help!
Yerterday a replaced the lower fusing roller, and the problem is solved. I checked the gears too.

[allan]

Re: C6000 corrugated paper

One of the one way bearings on the fuser exit get installed wrong way round and has the same result.