[Error Code] IC 601 error sc 40 - 008

[oommiiddaann]

hello dear Techs.
i've a ic601 that shows controller error sc 40 - 008 every 2or 3 prints an it has to restart by restart button.
how can i resolve that?

[Synthohol]

Re: IC 601 error sc 40 - 008

Code
40-008
Classification
Fan abnormality
Cause
The lock of FPGA fan (FM) is detected.
Measures to take when alert occurs
IC stops immediately.
Estimated abnormal parts

• FPGA fan (FM)
  
  Correction
  Turn OFF/ON the power switch of IC.
  biz hub PRESS Car's/CAP/C70hc/Car's/PRO COL K TROUBLESHOOTING > 5. TROUBLESHOOTING (IC-601)
  K -355
  Note
• The message "Please turn on power again" is displayed on the touch panel.

Solution
1. Turn OFF the power switch of IC and reboot it after 10 seconds.
2. Check that the FPGA fan (FM) is rotated.
3. Remove foreign materials if any.
4. When there is no foreign material, replace the FPGA fan (FM).
Faulty part isolation DIPSW
Control while detached

[oommiiddaann]

Re: IC 601 error sc 40 - 008

Code
40-008
Classification
Fan abnormality
Cause
The lock of FPGA fan (FM) is detected.
Measures to take when alert occurs
IC stops immediately.
Estimated abnormal parts

• FPGA fan (FM)
  
  Correction
  Turn OFF/ON the power switch of IC.
  biz hub PRESS Car's/CAP/C70hc/Car's/PRO COL K TROUBLESHOOTING > 5. TROUBLESHOOTING (IC-601)
  K -355
  Note
• The message "Please turn on power again" is displayed on the touch panel.

Solution
1. Turn OFF the power switch of IC and reboot it after 10 seconds.
2. Check that the FPGA fan (FM) is rotated.
3. Remove foreign materials if any.
4. When there is no foreign material, replace the FPGA fan (FM).
Faulty part isolation DIPSW
Control while detached

Thank you for your fast reply synthohol 🙏🌹

[Synthohol]

Re: IC 601 error sc 40 - 008

NP, there are only 3 fans in that box so it shouldnt be too hard to clean
good luck.